Electric skateboards are a fun and eco-friendly way to get around, but like any vehicle, they require maintenance and upkeep. One aspect of maintaining an electric skateboard is replacing the wheels. Over time, the wheels on your electric skateboard may wear down or become damaged, making it difficult to ride. In this article, we will discuss how to replace the wheels of electric skateboards.
How to replace wheels of electric skateboards?
Step 1: Gather your tools
Before you begin the process of replacing your electric skateboard wheels, you will need to gather some tools. You will need a skate tool or a wrench, depending on the type of bolts that hold the wheels in place. You may also need a flathead screwdriver, depending on the type of wheels you are replacing.
Step 2: Remove the old wheels
To remove the old wheels from your electric skateboard, start by turning your skateboard over so that the wheels are facing up. Using your skate tool or wrench, loosen the bolts that hold the wheels in place. Be sure to keep the nuts and bolts in a safe place so that you can use them later to attach the new wheels.
Once the bolts are loose, you should be able to remove the old wheels. If the wheels are difficult to remove, you can use a flathead screwdriver to pry them off. Be careful not to damage the bearings when removing the wheels.
Step 3: Clean the bearings
Once you have removed the old wheels, it is a good idea to clean the bearings. Bearings are the small metal rings that sit inside the wheels and allow them to spin. Over time, bearings can become dirty or clogged with debris, which can cause them to wear out more quickly.
To clean the bearings, remove them from the wheels and soak them in a container of rubbing alcohol. You can also use a bearing cleaner, which is a special solution designed for cleaning skateboard bearings. After soaking the bearings for a few minutes, use a clean rag to dry them off.
Step 4: Install the new wheels
Now that you have removed the old wheels and cleaned the bearings, it is time to install the new wheels. Start by placing the bearings back into the new wheels. You can do this by pressing them into place with your fingers or by using a bearing press tool.
Next, slide the new wheels onto the axles of your electric skateboard. Make sure that the bearings are properly seated in the wheels and that the wheels are facing the correct direction. Then, use your skate tool or wrench to tighten the bolts that hold the wheels in place. Be careful not to over-tighten the bolts, as this can damage the bearings.
Step 5: Test your new wheels
Once you have installed the new wheels, it is important to test them to make sure that they are properly attached and working correctly. Turn your electric skateboard over and give the wheels a spin. They should spin freely and smoothly, without any wobbling or shaking.
If the wheels do not spin smoothly, it may be because the bearings are not properly seated in the wheels. In this case, you will need to remove the wheels and re-install the bearings. If the wheels are still not spinning smoothly after re-installing the bearings, you may need to replace the bearings entirely.
In conclusion, replacing the wheels of an electric skateboard is a relatively simple process that can be done with just a few tools. By following these steps, you can keep your electric skateboard in top condition and enjoy a smooth, safe ride every time. Remember to always wear protective gear when riding your electric skateboard, and to perform regular maintenance and safety checks to ensure that it is in good working order.
Arnold A. Jones: Your go-to source for electric scooters, hoverboards, and skateboards! Riding enthusiast and expert sharing tips, trends, and insights for riders of all levels. Stay in the know with Arnold’s expertise.
Leave a Reply