Imagine cruising around on your hoverboard, enjoying the wind in your hair and the freedom of movement. But suddenly, you notice that the hoverboard one side is not working, leaving you to ride unevenly and potentially dangerous. Don’t worry; you’re not alone. It is a common issue that many hoverboard users face. Let’s look at the step-by-step guide on troubleshooting and fixing your hoverboard so that it’s back to its full functionality in no time. So, please sit back, relax, and let’s get your hoverboard back in action!
Hoverboard one side not working- Quick Fixes for your hoverboard
Check the Battery Level
The first step is to check the battery level of your hoverboard. If the battery is low or not charged, it may be the main issue that your hoverboard is not working on one side. Connect the hoverboard to the charger and wait for it to fully charge before using it again.
Check for Loose Wires
If the battery level isn’t the issue, check for loose wires. Hoverboards have a lot of wiring inside them, and if a wire becomes disconnected or loose, it can cause one side to stop working.
To check for loose wires, remove the hoverboard’s outer casing carefully.
Now, take a close look at the wiring inside. Check for any wires that may be disconnected or frayed. If you find any loose wires, carefully reattach them and make sure they’re secure. Ensure you note which wires you’re reattaching and where they should be connected.
Check the Gyroscope
Hoverboards use a gyroscope to maintain their balance and stability. If the gyroscope is not functioning correctly, it can cause one side of the hoverboard to stop working. You need to calibrate the gyroscope.
Calibrating the gyroscope involves standing the hoverboard up vertically and turning it off and on again. It will recalibrate the sensors and restore the hoverboard’s balance.
If the gyroscope is still not functioning correctly after calibration, it may need to be replaced.
Check the Motor
If the battery level, wiring, and gyroscope work fine, it’s time to check the motor. The motor is responsible for powering the wheels, and if it’s not working correctly, it can cause one side of the hoverboard to stop working.
Remove the outer casing of the hoverboard and locate the motor.
Check to see if it’s making any strange noises or running smoothly. The motor may need to be replaced if it is making strange noises.
If it’s running smoothly, you can swap the motor from working to non-working. If the non-working side begins to work, you’ll know that the motor needs to be replaced.
Contact Customer Support
If you’ve gone through all the steps above and the hoverboard still isn’t working on one side, it may be time to contact customer support.
Depending on the warranty of your hoverboard, you may be able to have it repaired or replaced at no cost. Contact the manufacturer or the retailer where you purchased the hoverboard to see your options.
Final words:
While it may seem intimidating initially, you can quickly diagnose and repair your hoverboard with patience and determination. Whether it’s a loose wire, a malfunctioning gyro sensor, or a faulty motor, our guide has you covered. Remember always to put safety first when handling your hoverboard and never attempt repairs beyond your expertise. So, get back out there, hit the pavement, and enjoy the full functionality of your hoverboard once again!
Frequently Asked Questions (FAQs)
- Is it safe to ride a hoverboard with only one working side?
It is not safe to ride a hoverboard with only one working side. It can cause instability and lead to accidents.
- Can a bad charging port cause one side of my hoverboard to stop working?
A bad charging port can cause one side of your hoverboard to stop working. Check the charging port and cable before attempting any other repairs.
- Why did my hoverboard suddenly stop working?
There may be several reasons why your hoverboard suddenly stopped working, such as a low battery, a faulty motor, a damaged circuit board, or a disconnected wire. It’s best to troubleshoot and diagnose the issue to determine the cause of the problem.
Leave a Reply